| Introduction： Advantage:
* Excellent compression resistance;
* Safety warning effect (the protuberance portion can produce the reflected light so that it can provide an audible warning on high speed roads,a proven safety measure to inform motorists and pedestrians or serve as noise generators when run across a road,or attempt to wake a sleeping driver when installed in the shoulder of a road)
Consumption (Actual consumption depends on the roughness of pavement)
|
Reference Table of Material Consumption |
|
|
Thermoplastic profiled |
|
Paint |
6kg/㎡ |
|
Glass Beads |
350g/㎡ | Technical Data:
·Curing time:≤3minutes
·Compression strength:≥12(23℃)
·Anti slide swing valve:≥45BPN
Color:White/Yellow/Customize color
Typical installation areas:
·High grade highway boundary line,corner,diversion area,entrance marking,bridge,tunnel,steep slope and other sections
·City road junction parking line,lane boundary,special lane demarcation marking
·Other places that must have a hint function marking
The matters needing to attention during the construction
1. The road surface should be dry during construction and keep the road clean
2. During the construction,the temperature should not be below 15 ℃,if the road surface is humidity construction is forbidden
3. When the paint is heated in the hot melt kettle,the temperature should be controlled at 180℃ to 220℃,at the same time fully mixing
4. After the primer completely dry,then to apply the paint
|
